StopDamp+ Injection Cream | Rising Damp Treatment

What Is StopDamp+ Injection Cream?

StopDamp+ is an injection cream formulated to treat rising damp in masonry walls. It's injected into a prepared line of holes near the base of the wall, where it forms a water-repellent barrier that helps stop moisture rising through the structure.

How It Works

StopDamp+ is applied directly into the wall through strategically positioned injection holes. The proprietary formula diffuses into the surrounding masonry, creating a water-repellent barrier that interrupts the upward movement of moisture.

Ground moisture → Wall → StopDamp+ barrier → Reduced upward moisture movement

StopDamp+ injection cream being applied to a masonry wall with a caulking gun — Applied via injection gun into a prepared line of holes at the base of a masonry wall.

Why Choose StopDamp+?

Formulated specifically for rising-damp treatment
Clean, controlled injection application
Suitable for common masonry construction
No need to remove the entire wall
Practical for both professional and properly prepared DIY use

StopDamp+ cartridge with green applicator gun — 310ml cartridge, designed for use with a standard applicator gun.

Application Guide

Correct preparation and application are essential for effective treatment. See the full StopDamp+ Installation Guide for detailed instructions.

Four step diagram: drill holes, clear holes, insert StopDamp+ cream, finish the job — The four-step application process: drill, clear, inject, finish.

Coverage & Quantity

The amount of StopDamp+ required depends on factors such as wall length, wall thickness, and hole spacing. Use the coverage calculator to work out the quantity needed for your project.

Five StopDamp+ Injection Cream cartridges, covering approximately 15 linear metres — 5 cartridges (310ml each) cover approximately 15 linear metres of 115mm-thick sandcrete block — use the coverage calculator to confirm the quantity for your wall thickness.

Technical Information

For detailed product information, application requirements, storage instructions, and further technical details, refer to the StopDamp+ Technical Information Sheet.

Frequently Asked Questions

Can StopDamp+ be used on sandcrete block walls?
Yes, where the wall and damp condition are suitable for injection treatment.

Does the wall need to be completely dry before treatment?
No. Rising-damp treatment is carried out on damp masonry. However, the wall should first be assessed to establish the source of moisture.

How long does the wall take to dry?
Drying time varies depending on wall thickness, moisture levels, ventilation, salts, and environmental conditions.

Can I install StopDamp+ myself?
Yes — it can be applied by a competent DIY user or a professional installer, provided the correct preparation, drilling pattern, and injection procedure are followed.